ELEC BUMI SDN BHD


	Airport Lighting Equipment

	Isolating Transformers & Connectors Kits

	Approach Masts

	Airfield Lighting Cable

	Airfield Lighting Lamps

	Windcones & Windsocks

	Grouts for Airport Inset Lights

	CCR & Control System

weber.tec cable grout - certite cable grout

weber.tec cable grout is a low-modulus, semi-flexible polyester resin compound for filling cable slots. Can be used in asphalt, bitumen and concrete surfaces. Use for gaps 5 mm to 16 mm wide.

Uses

Grouting runway lights
Fixing vertical bolts, starter bars and dowels
Grouting anchor bolts and holding down bolts

Features and benefits:

Easy to mix and place
Does not segregate or bleed
Rapid setting for quick return to service
Can be used in cold weather down to 0°C
Good abrasion resistance
Excellent chemical resistance
Available in two colour grades: black for asphalt; grey for concrete
Available in 3 grades depending on application temperatures

weber.tec grout FG - certite pourable grout fine grade

weber.tec grout FG is a two-component polyester grout for anchoring and fixing. Fast-setting for rapid installation and can be used down to 0°C. Flowing grout to fill gaps of between 5 mm up to 90 mm dependent upon bulking out with aggregate.

Uses

Grouting runway lights
Fixing vertical bolts, starter bars and dowels
Grouting anchor bolts and holding down bolts

Features and benefits:

Fast-seting with rapid strength gain, allowing loads to be applied within 2 hours at 20°C
Economical usage through part mixing by volume
Available in standard, rapid and tropical grades depending upon temperature
Excellent adhesion to concrete and asphalt substrates
Can be bulked out for varying gap sizes, 5 mm – 90 mm
Proven technology with reliability

weber.tec - bedding mortar TG

weber.tec bedding mortar TG is a three-component, polyester-based mortar for the bedding and fixing of airport landing lights and runway fixtures. It has been formulated for easy mixing and placement, even at high temperatures and, when cured, provides a durable, chemically resistant bedding and fixing material with good bond strength.

Uses

bedding of airport landing lights
bedding of duct frames
fixing precast concrete units
fixing runway fixtures

weber.tec bedding mortar TG is suitable for external use on:

concrete
asphalt

Fully complies with the Highways Agency Design Manual Document HA 104/02 for bedding mortar.

Features and benefits:

Meets the performance specification resulting from the Highways Agency sponsored LINK research contract carried out by Nottingham University’s Department of Civil Engineering (1977)
Easy to mix and place
15 minute working time for ease of placement
Rapid setting for quick return to service (within 2 hours at 20°C)
Special tropical grade for application in temperatures around 30°C
Good chemical and freeze/thaw resistance